This is Talon's flagship F7 flight controller.
Using a dual gyro setup in 90° phase and a F7 processor will have your quad dialed in to the max!
- MCU: STM32F722RET6 216MHz
- 2x ICM20602 GYROS 90 deg phase
- Built in Betaflight OSD
- Up to 8S (36V) direct battery power
- Buzzer pads for external buzzer
- Built in voltage monitoring resistor
- 5V 2A BEC
- Dedicated LDO for Gyro, noise free gyro power
- Dedicated LDO for OSD, cleaner OSD signal
- Led strip shares 5V with 5V/2A BEC
- 6 UARTS: UART1, UART2, UART3, UART4, UART5, UART6
- Built in camera control pin with resistor and capacitor
- 5 Full UARTS with RX AND TX pins
- Logical pin layout for cleanest build possible
- 8 pin 4 IN 1 ESC plug
- Remapable LED pad for additional motor output
- TX3, RX3 can be used for I2C for external compass
- 5V, VBAT selectable VTX and CAM power
- 16M Blackbox flash chip
- No flicker VTX pit mode switch (positive switch)
- M4 Can be selected either led_strip signal or M4 signal for RPM filtering
20 X 20 mounting hole with true 25mm board dimensions
TO GET MOTOR 4 TO WORK PLEASE USE THE CLI COMMAND BELOW USING BETAFLIGHT V4.0.4. A CUSTOM HEX IS COMING SOON FOR 4.0.4.
Resource MOTOR 6 None
Resource MOTOR 4 C08
To get 5V to your VTX please go to the mode tab in Betaflight and setup a mode switch for vtx_pit
Why order from Rising Sun FPV?• FREE Express* shipping over $250.
• Orders ship out of Townsville, QLD, Australia at 1530.
• Active on Instagram - Tag us or DM us!
• Watch what we are up to on our YouTube Channel!
• Join our Facebook Page for updates and RSFPV news.
• GST Registered.
• Gifts with every order!
• Veteran Owned and Operated.
• Defence and Service discounts - Apply Here
• 3D Printing and Custom design – Inquire Here.
• Visit us at our Store and have a yarn.
• FPV Drone service, support and repairs.